Product Sections

Main Pages

New Products

5mm cord 30m long

5mm cord 20m long

2mm rope, 20m long

5mm cord 10m length

Stuff winch for 5mm rope, will take up to 50m

Small winch for 2mm rope

500g messanger weight

80 g brass messanger weight

1.5 litres stainless steel sample bottle

1.5 litres simple water sample bottle manufactured in 316 grade stainless steel
find out more

1.0 litres stainless steel sample bottle

1.0 litres simple water sample bottle manufactured in 316 grade stainless steel
find out more

Best Sellers

9 cubm/hr 3.00m long fine bubble air diffuser for waste water treatment

9 cubm/hr 3.00m long fine bubble air diffuser for waste water treatment

Fine bubble high performance air diffusers. Semi flexible diffuser construction 300cm long 32mm diameter. Maximum recommended air flowrate is 10 cubic metres of air per hour. Materials of construction are plastic with 316 stainless steel end fittings, aslo fitted with non return valve in diffuser. Diffuser contains its own internal fused silica bead ballast. End fittings are 1/2" acetyl plastic as standard.

The Dryden Air diffuser is the leading air diffuser used in UK aquaculture, treatment of leachate water on landfill sites, sewerage treatment and numerous other applications.
find out more

AFM grade 1 filtration media

AFM grade 1 filtration media

AFM (Advanced Filtration Media) grade 1 is the standard sized AFM media equivalent to 16 x 30 grade sand. M

Supplied in 25kg sacks, grade 1 particle size 0.5mm to 1.10mm. Media should be used on top of a layer of grade 2 AFM.

Price is per 25kg sack
(For bulk quantities and dealer prices please contact us directly at aqua@drydenaqua.com )
find out more

Oxygen standard probe

Oxygen standard probe

High performance, very robust galvanic oxygen probe for the measurment of dissolved oxygen in water, waste water and air. Completely sealed internals, so there is no risk of insulation failure, heavy duty Sub Sea cable, high mv out-put 6.5 mv to approx 1mg/l dissolved oxygen. Ideal probe for the Dryden Aqua, AquaTraul system or your own oxygen monitors such as multichannel or stand-alone PLC based systems.

The probe is supplied with 5 meters of cable (alternative lengths available), pack of 5 membranes and 50ml of electrolyte.
find out more

Ozone detector card

Ozone detector card

Ozone detector card, each card can take five measurements of ozone and five cards are supplied with the pack. The card will measure ozone levels in air from 10ppb to 105ppb, this is the important range over which human health, respiratory and allergic reactions may be initiated. The card is intended as an indicator to help protect the young, elderly, people with respiratory or allergic reactions as well as the active sports person that does not want to be exposed to pollution while enjoying excercise in towns or on the top of a mountain.

The card is also important as a personnel monitor in industry and in the office, where laser printers and photocopiers and other machines all produce ozone. The legal limit in the UK for 8 hour exposure is presently set at 100ppb, any level above this concentration is un-acceptable and illegal in the work-place.
find out more

ET120 linear air blower

standard float LR03 switch 10m cable

standard float LR03 switch 10m cable

This is a standard general purpose low cost float switch. The cable is PVC. A pivot point weight can be added to the cable if required.

The float switch is rated for 240v ac 10 amp inductive load,

The float switch can switch small pumps on and off directly, however it possible it is always best to use a low control voltage which is used to activate a remote relay. The remote relay can then switch heavy loads such as pumps on or off.
find out more

Aquaculture | Water Technology | Environmental Products.....delivered worldwide

UVc disinfection

dry1 | Drinking water systems | UVc disinfection

UVc disinfection DBD2

UVc disinfection DBD2

Ref: 4.6.3.1


Price: £398.00 / €517.40 (Excluding VAT at 17.5%)

Stainless steel UVc disinfection unit, for the treatment of up to 2.5 cubic metres of water per hour with an irradiation dose of 40mj, sufficient to give a log 3 (99.9%) reduction in the bacterial levels. The performance of the unit should be occassionally checked using our bacterial dip slides, especially if you water contains a high level of iron or manganese. If the water has a high level of solids it should be filterd down to 5 microns prior to UV treatment.
more information

UVc disinfection DBD3

UVc disinfection DBD3

Ref: 4.6.3.2


Price: £484.00 / €629.20 (Excluding VAT at 17.5%)

Stainless steel UVc disinfection unit, for the treatment of up to 3.5 cubic metres of water per hour with an irradiation dose of 40mj, sufficient to give a log 3 (99.9%) reduction in the bacterial levels. The performance of the unit should be occassionally checked using our bacterial dip slides, especially if you water contains a high level of iron or manganese. If the water has a high level of solids it should be filterd down to 5 microns prior to UV treatment.
more information

UVc disinfection DBD2 with UVc sensor

UVc disinfection DBD2 with UVc sensor

Ref: 4.6.3.3


Price: £692.00 / €899.60 (Excluding VAT at 17.5%)

Stainless steel UVc disinfection unit, for the treatment of up to 2.5 cubic metres of water per hour with an irradiation dose of 40mj, sufficient to give a log 3 (99.9%) reduction in the bacterial levels. The performance of the unit should be occassionally checked using our bacterial dip slides, especially if you water contains a high level of iron or manganese. If the water has a high level of solids it should be filterd down to 5 microns prior to UV treatment.

This unit has a built in UVc sensor which will activate an alarm should the UV level received by the water starts to drop. This is an indication that there is a high level of organic matter or solids in the water, or the quarts glass sleeve has become fouled. For highest security we therefore recommend the UV sensor units.
more information

UVc disinfection DBD3 with UVc sensor

UVc disinfection DBD3 with UVc sensor

Ref: 4.6.3.4


Price: £814.00 / €1,058.20 (Excluding VAT at 17.5%)

Stainless steel UVc disinfection unit, for the treatment of up to 3.5 cubic metres of water per hour with an irradiation dose of 40mj, sufficient to give a log 3 (99.9%) reduction in the bacterial levels. The performance of the unit should be occassionally checked using our bacterial dip slides, especially if you water contains a high level of iron or manganese. If the water has a high level of solids it should be filterd down to 5 microns prior to UV treatment.

This unit has a built in UVc sensor which will activate an alarm should the UV level received by the water starts to drop. This is an indication that there is a high level of organic matter or solids in the water, or the quarts glass sleeve has become fouled. For highest security we therefore recommend the UV sensor units.
more information

dry1 > Drinking water systems > UVc disinfection

Prices shown are all ex-works Edinburgh Scotland