This Phosphate Test kit includes 50 powder pillows, two testing vials and a reference card with directions. Gives accurate results after only 60-seconds, and measures phosphate from 0 to 1000 ppm. 50 test per bottle.
find out more

Fine bubble high performance air diffusers. Semi flexible diffuser construction 300cm long 32mm diameter. Maximum recommended air flowrate is 10 cubic metres of air per hour. Materials of construction are plastic with 316 stainless steel end fittings, aslo fitted with non return valve in diffuser. Diffuser contains its own internal fused silica bead ballast. End fittings are 1/2" acetyl plastic as standard.

The Dryden Air diffuser is the leading air diffuser used in UK aquaculture, treatment of leachate water on landfill sites, sewerage treatment and numerous other applications.
find out more

AFM (Advanced Filtration Media) grade 1 is the standard sized AFM media equivalent to 16 x 30 grade sand. M

Supplied in 25kg sacks, grade 1 particle size 0.5mm to 1.10mm. Media should be used on top of a layer of grade 2 AFM.

Price is per 25kg sack
(For bulk quantities and dealer prices please contact us directly at aqua@drydenaqua.com )
find out more

High performance, very robust galvanic oxygen probe for the measurment of dissolved oxygen in water, waste water and air. Completely sealed internals, so there is no risk of insulation failure, heavy duty Sub Sea cable, high mv out-put 6.5 mv to approx 1mg/l dissolved oxygen. Ideal probe for the Dryden Aqua, AquaTraul system or your own oxygen monitors such as multichannel or stand-alone PLC based systems.

The probe is supplied with 5 meters of cable (alternative lengths available), pack of 5 membranes and 50ml of electrolyte.
find out more

Packet of 25 membranes for the AquaTraul oxygen probe, using these membranes will convert the probe to give readings in mg/l
find out more

Electrolyte for AquaTraul oxygen probe
find out more

This is a standard general purpose low cost float switch. The cable is PVC. A pivot point weight can be added to the cable if required.

The float switch is rated for 240v ac 10 amp inductive load,

The float switch can switch small pumps on and off directly, however it possible it is always best to use a low control voltage which is used to activate a remote relay. The remote relay can then switch heavy loads such as pumps on or off.
find out more

Tear drop water level float switch, the float switch measures approximately 125mm in diameter., total weight including cable 1.3kg .
find out more