NQA
European Commission project  for your
afm logo of dryden aqua active filter media

factory.jpg (3825 bytes)

| Homepage | Contact us  | About us |  Shop ||

Environmental & sustainable water treatment to save the planet
| DrydenAqua |  AFM  |  Ozone | Membrane filtration | Swimming Pools |  Leachate  Treatment |
 specification & installation of the skid  system 
 
AFM packaged Systems

for Clean Water and Wastewater treatment

1 to 8 cubm per hour
The small scale AFM systems can be used to test AFM filtration systems prior to the installation of full scale systems.  However in many cases a water treatment rate up to 8 cubic metres of water per hour is sufficient for many clean water and waste water treatment applications. AFM small scale systems now for the first time provide an inexpensive convenient means of mechanically filtering virtually any type of water of any solids loading. Typically AFM will remove around 90% of the solids and 90% of the COD, however when used with NoPhos coagulation an even high performance may be achieved. Water quality improvement can be dramatic and payback for the system are usually measured in months.
System details

The AFM small scale treatment systems are completely self contained pressure filtration units mounted on a stainless steel skid.  The equipment may be used to evaluate the performance of AFM water treatment in a variety of different water types ranging from ultra clean water, to sewage works and industrial effluent.  The system can also be used as the effluent treatment system for a clean water or waste water application. 

The system is completely self contained with all connections to your facilities being achieved by means of flexible hose or rigid pipe

Two system are available;

  • 1 to 3 cubm/hr
  • 3  to 8 cubm/hr
Applications

The small scale systems are being used for the following applications;

  • tertiary treatment of sewage effluent
  • brewery waste water
  • industrial waste water
  • landfill leachate
  • wash water from fruit and vegetables
  • algae removal from ponds
  • Electro plating
  • removal of phosphate

 

1 to 3 cubm/hr system treating sewage effluent prior to installation of a full scale system.

The small scale systems have coped with solids load up to 4000 mg/l/  However at very high loads the flow rate should be reduced, back-flush frequency increased and air scouring included. The maximum recommend solids load is 250mg/l.