click here for our activated carbon
We can provide a range of Activated carbon filters from 630mm diameter to
2200mm diameter. Bed depth is 1.2m, manufacture in accordance to DIN
specification, with a working pressure of 2.5 bar, Filters with a maximum
working pressure of 10 bar can also be provided.
The details provided below are for our 630mm diam Activated carbon filter.
-
Maximum water flow rating
4 to 8 cubm/hr
-
RP construction with PVC liner,
-
Pressure rating
from 2.5 bar
up to 10 bar
(please advise rating required)
-
Diam = 630mm overall height 2300mm
(larger sizes are available)
-
Activated carbon bed depth 1200mm
-
Quantity of activated carbon 200 kg (supplied with filter)
-
Filter base material 50 kg of AFM grade 2 (supplied with filter)
Note. There should always be some water flow through the filter, if
the filter is turned off for any more than a few hours, conduct a
back-wash before going back on-line. Back-wash the filter once a
week when used to treat municipal mains water supplies.
|
Valve Manifold arrangement
If the valve manifold is
provide by Dryden Aqua, the components will be provided loose for
assembly on-site. PVC solvent glue, 2 brushes, sand paper, MEK clean and
a cloth will be required.
It is also important
to securely anchor the pipe to a wall or support from the floor. Do not
hang the valve manifold from the filter. Avoid water hammer, move the
laves slowly ( over 30 seconds) to allow the water flow to build
gradually.
A = connection to the top DN80
filter inlet
B = connection to the bottom
DN80 inlet
C = 90mm pvc socket
connection to water supply
D = 90mm connection for
filtered water
E = 90mm connection for
back-wash and rinse water to drain
|
| |
|
|
 |
Dryden Aqua home
pdf downloads
